先把人物去背
______________________________________________________
Thanks to ImageShack for Free Image Hosting
然後複製原圖,最後如上圖
______________________________________________________
Thanks to ImageShack for Free Image Hosting
作用在複製圖層,執行FILTER/BLUR/GAUSSIAN BLUR,這裡數值用1.3
______________________________________________________
Thanks to ImageShack for Free Image Hosting
接著再執行FILTER/STYLIZE/GLOWING EDGES,這裡數值為Edge Width:4,Edge Brightness:8,Smoothness:5,最後如圖
______________________________________________________
Thanks to ImageShack for Free Image Hosting
完成後,如圖
______________________________________________________
Thanks to ImageShack for Free Image Hosting
把複製圖層的 混合模式設為Screen
______________________________________________________
Thanks to ImageShack for Free Image Hosting
把原圖複製一個,並把它放到最上面
______________________________________________________
Thanks to ImageShack for Free Image Hosting
接著執行FILTER>SKETCH>CHROME,如圖設定
______________________________________________________
Thanks to ImageShack for Free Image Hosting
把原圖COPY圖層的 混合模式設為OVERLAY
______________________________________________________
Thanks to ImageShack for Free Image Hosting
1.回到原圖的圖層
2.按Ctrl+U,選取COLORIZE
3.調到你要的數值,這裡為HUE:205,SATURATION:76,LIGHTNESS:+27,完成按OK
______________________________________________________
Thanks to ImageShack for Free Image Hosting
1.回到複製的圖層
2.按Ctrl+U,選取COLORIZE
3.調到你要的數值,這裡為HUE:218,SATURATION:26,LIGHTNESS:+49,完成按OK
______________________________________________________
Thanks to ImageShack for Free Image Hosting
新增一個LAYER1,並且灌入白色
______________________________________________________
Thanks to ImageShack for Free Image Hosting
把原圖COPY,複製一個並放到最上方,混合模式設為SOFT LIGHT
______________________________________________________
Thanks to ImageShack for Free Image Hosting
1.分別在原圖COPY和原圖COPY2各增加兩個圖層遮色片
2.因為臉部地方反光的地方把臉的輪廓給遮住了,所以就把那些反光的地方塗黑,
讓臉的輪廓顯示出來,大致上就是這樣了,製作過程中所輸入的數值和去背,還有圖層的混合模式都會影響到最後的感覺,這些感覺你就試到自己要的感覺吧